LG dryer d80, d85, d90 and d95 codes mean the exhaust vent is roughly 80–95% blocked — clean the lint filter, the duct behind the dryer and the vent to the outside, and don't run the dryer at d90 or higher. tE1 and tE3 are temperature (thermistor) and heat faults, gAS means a gas dryer isn't heating, dE means the door switch is open and PS means the supply voltage is wrong. After the vent is cleaned, codes that return need a technician.
| Code | What it means | What you can do |
|---|---|---|
| d80 / d85 | Exhaust about 80–85% restricted | Clean the full vent run; drying stays slow until you do. |
| d90 / d95 | Exhaust about 90–95% restricted | Stop using the dryer until the vent is cleaned or repaired — fire hazard. |
| HS | Humidity sensor error, or vent test run on a warm dryer | Run the test cold; if HS returns, the sensor needs service. |
| Code | What it means | What you can do |
|---|---|---|
| tE1 | Thermistor (temperature sensor) error | Sensor or wiring — call for repair. |
| tE3 | Heat fault — thermistor out of range, tripped thermostat or wrong voltage | Check the 240V breaker and clean the vent; then heater circuit or high-limit. |
| gAS | Gas dryer not heating | Gas valve on? Then igniter, flame sensor or gas valve coils — call. |
| Code | What it means | What you can do |
|---|---|---|
| dE | Door not closed — door switch open | Close firmly; repeats mean the door switch. |
| PS / nP | Supply voltage incorrect or power interrupted | Check outlet and breaker; electric dryers need 240V. |
| F0 / IF | Lint filter not detected | Seat the lint filter fully. |
| CL | Child lock on (not an error) | Hold Child Lock for 3 seconds. |
Codes and their meaning can vary by model and production year, and the same code can have different causes. Where sources disagree we say so; in every case the exact cause is confirmed only by a technician's on-site diagnosis. Your owner's manual has the definitive list for your model.
Unplug the appliance (or switch off its breaker) before touching anything inside it, and never open a sealed refrigeration system, a gas valve or a microwave. If a code points to a part, the part has to be tested before it is replaced; we do that on the $75 diagnostic visit, credited toward the repair.
The vent is about 90% blocked. Stop using the dryer and clean or repair the vent.
No heat or a temperature fault — check the breaker and vent, then the heater circuit.
We clear what we can reach at the dryer; long or rooftop runs need a vent-cleaning company.
Yes, including igniters, flame sensors and gas valve coils. We don't connect gas lines.
Sources: LG US: dryer troubleshooting and error codes.
Browse all repair guides by appliance
Call (702) 744-2944 or book online. The in-home diagnostic is $75 and is credited toward the repair. We serve the whole Las Vegas Valley.
A 38-year-old Sub-Zero 500 Series freezer most companies would have written off: we replaced the compressor, evaporator, heat exchanger and drier with OEM parts and retrofitted it from R12 to a modern refrigerant.
We use cookies to measure site traffic with Google Analytics and to remember your choice. You can decline analytics cookies. Details in our Privacy Policy.
Tell us what’s wrong — our technician
will contact you and help right away
Your application has been successfully accepted,
Our manager will contact you soon.
